Commercial Electric 56567142 Guía De Uso Y Cuidado página 2

3. Unplug the terminal ground wire(D) connection between the wire way cover(E) and the housing (A).
4. Set the wire way cover aside in a safe place until ready to reattach it to the housing (A).
surFace MountIng
1. With help from another person, temporarily hold the fixture housing (A) up to the ceiling to determine the best mounting
position and which knock out hole to use for wiring the fixture.
2. Mark two keyhole locations 47in. apart on the mounting surface.
A
B
3. Feed the electrical connection wires through any knock out hole.
4. Add a ring (DD) on the middle knockout hole to protect the wires.
5. Insert the hot and neutral (black and white) wires from the electrical box into the wire connectors of the same color
wires from the housing (A).
6. Insert the ground wire from the electrical box into the wire connector attached to the green wire from the housing (A).
7. If a 0-10v dimming circuit is available, insert the purple and gray wires from the electrical box into the wire connectors
of the same color wires from the housing (A).
NOTE: Tuck all electrical connections into the electrical box.
NOTE: Electrical connections will be covered by the wire way cover (E).
A
B
B
A
E
Wire
connector
DD
Metal Tab from
Wire Way Cover
Keyholes
Knock out holes
Knock
out holes
E
2