Commercial Electric 56567142 Guía De Uso Y Cuidado página 4

Idiomas disponibles

susPenDeD MountIng

1. Before installing the fixture, prepare below standard parts in advance (not included).

Part

Description

Mounting Plate

Mounting Screw

nut

3/8" Conduit

Hook

NOTE: UL LISTED: CCn:FKAV/7 TyPE: 1/2 FOR THREADED COUPLER.

2. Mark two spots on the ceiling 32.9 in. (1120mm) apart for suspension mounting before the installation.

MOUnTInG TO A DRyWALL CEILInG:

a. Drill two holes large enough to clear the closed flaps of the butterfly nut on a toggle bolt (not included).

b. Fasten the toggle bolt into the butterfly nut before inserting the flaps into the ceiling.

Tighten the toggle bolt.

MOUnTInG TO A WOOD CEILInG:

a. Drill two 1/16 in. diameter holes in the ceiling to accommodate hook screws (not included).

b. Tighten the hook screw (not included) into the ceiling.

3. Hang the mounting chain (EE) over each hook (not included) that has been installed on the ceiling.

4. Attach the V clip chain (FF) to the hanging holes on the fixture body (A) and close the hook with pliers to secure it.

5. Connect the mounting chain (EE) and V clip chain (FF) and make sure the joints are locked in place.

6. Open the diffuser (B) , feed the conduit (not included) and all the electrical connection wires through the knockout hole and

tighten the conduit securely.

7. Insert the hot and neutral (black and white) wires from the electrical box into the wire connectors of the same color wires

from the housing (A).

8. Insert the ground wire from the electrical box into the wire connector attached to the green wire from the housing (A).

9. If a 0-10v dimming circuit is available, insert the purple and gray wires from the electrical box into the wire connectors of

the same color wires from the housing (A).

NOTE: Tuck all electrical connections into the electrical box.

NOTE: Electrical connections will be covered by the wire way cover (E).

Quantity

32.9 in. (1120mm)