Publicidad
Idiomas disponibles
Idiomas disponibles
4. The preset temperature of any stage can be adjusted up or down by simply pressing
the " –" or "+" buttons. Each press will change the preset temperature by one degree. You
can also press and hold the "–" or "+" buttons to scroll for larger temperature adjustments.
Note: When the temperature is adjusted up or down the preset stage name will disappear
from the top of the display and the word "SET" will appear to the left of the adjusted
temperature as the thermometer has entered manual mode.
5. Once the desired target temperature is set and the cooking process begins, the
thermometer will make three different audible alerts. The thermometer will make a 2-beep
alert and the red LED will begin flashing when the current temperature reaches 5°F/3°C
before the target temperature. When the target temperature is reached, the thermometer
will make a 1-beep alert and the red LED will begin flashing. When the current
temperature reaches 3°F/2°C above the target temperature, the thermometer will make a
fast 2-beep alert and the red LED will begin flashing.
Note: Press any button to stop the alerts.
6. After the measurement has been taken you can turn the unit off by pressing and
holding the POWER ( ) button. If you forget to turn the unit off, the auto-off feature will
automatically turn the thermometer off after 60 minutes.
Note: The auto-off feature can be disabled by pressing and holding the "-" and "+" buttons
simultaneously for 2-3 seconds. The unit will beep and an "x" inside a circle will appear to
the left of the target temperature indicating that the auto-off function has been disabled.
To enable the auto-off function press and hold the "-" and "+" buttons again.
The stainless-steel probe can get very hot. Always wear heat resistant gloves when
handling.
Using the Vessel Clip and Heat/Splatter Shield
• The thermometer comes with a vessel clip and heat/splatter shield. The heat/splatter
shield helps to shield the unit from heat during the cooking process and also keeps the
unit clean by preventing splatter. The heat/splatter shield is attached to the thermometer
by inserting the probe into the hole in the center of the shield and sliding it towards the
bottom of the thermometer housing. The open side of the shield should be facing up.
• To attach the vessel clip, slide the probe into the top and bottom holes of the clip. To
adjust the clip up and down slide it along the length of the probe until the desired position
is reached. If the clip will not slide easily, the clip can be squeezed together to reduce the
amount of grip force, allowing the clip to slide up and down. Push the clip down onto the
side of the pot and position the thermometer until the tip of the probe is just above the
bottom of the pot. Do not let the tip of the probe touch the bottom of the pot.
Note: The included probe sheath should be used to protect the probe when not in use and
during storage.
3
Publicidad
