Connecting To A Computer; Installing The Software - Silvercrest SND 4600 A1 Instrucciones De Uso

Connecting to a computer

NOTE
► Use only the original accessory parts recommended by the
manufacturer for this appliance.
System requirements
Operating system: Windows Vista/7/8/10/11, Mac 10.10‒12
Slot: USB connection (USB-A)
♦ Connect the USB-C plug on the USB cable
on the scanner.
♦ Connect the USB-A plug on the USB cable
PC. The computer recognises the new hardware and starts in-
stalling the drivers automatically. This process can take a around
a minute. The PWR LED
properly connected.

Installing the software

ATTENTION
► Important files may be changed or overwritten during the
installation of the software! Before installing the installing
the software, make a backup of your original files to ensure
that you will be able to access them later if problems occur
during installation.
Installation on Windows
NOTE
► If your computer does not have a CD drive, visit the following
website to download the software:
www.kompernass.com/365299_2204
│ GB │ IE
■ 8
1
lights up as soon as the scanner is
8
to the USB-C port
8
to a powered-on
SND 4600 A1
3