claber meteo 8323 Manual De Instrucciones página 43

Connections
• Soon after, press the remote control button
to select the number of the RF Unit (Unit1, Unit2, etc...) to connect to
the programmable solenoid valve
• No later than one minute after the completion of step
the S1 button of the remote control with the aid of a pointed object,
such as a paper clip
This will activate the connection procedure: the display of the
remote control will blink to indicate that the two components are
attempting to establish a wireless connection (radio frequency).
• The outcome of the connection procedure is indicated on the remote
control display when the RF symbol
- connection failed: RF
symbol
ERR
- connection successful: RF
Whatever the outcome, the connection is concluded at the
solenoid valve with a RESET. Following the reset, it will be
advisable to check the CLOCK symbol
solenoid valve (colours and blink codes are explained under the "CLOCK
symbol " on page 34).
➌
.
blinking.
➋
.
stops blinking:
symbol permanently alight and error
symbol off.
one or more times
➊
press
on the panel of the
UK UK
43 43