BaByliss PRO FX726 Manual De Instrucciones página 3

2. Make sure the switch on the trimmer is in the "O" (OFF) position. Connect the
charging jack into the receptacle on the bottom of the trimmer. Plug the adapter
into an electrical outlet that has the same voltage listed on the label affixed to the
adapter. The charging indicator will light up and blink to indicate that the charging
has begun. Charging is complete after 3 hours. User will see LED light has stopped
blinking and is now solid.
3. The adapter may become warm while charging. This is normal.
4. Preserving the battery: In order to maintain the optimum capacity of the
rechargeable battery, the trimmer should be recharged for 3 hours approximately
every 6 months.
5. Make sure the switch is in the "O" (0FF) position when the trimmer is not operating.
6. Remove hair trimmings and debris from the blades using the provided cleaning
brush. Wipe the housing clean with a dry cloth.
7. Apply a few drops of lubricating oil to the blades, and wipe off any excess oil with a
dry cloth. This last procedure is important for the proper maintenance of the blades.
8. If the charging light starts to flash rapidly (more than 4 flashes per second), the
appliance is faulty. If this happens, stop charging and remove the adapter from the
outlet and contact an authorized service center.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
FX726 IB-17107A.indd 5-6 FX726 IB-17107A.indd 5-6
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: BaBylissPRO
®
Model No.: FX726
Description: Trimmer
Responsible Party: Conair LLC
1 Cummings Point Road
Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 12/28/2020
FOR DIRECT PLUG-IN OPERATION
Make sure trimmer is off. Connect charging jack into the receptacle at the end of
trimmer and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to "I" position. To stop operation, set to the "0" position.
2021/9/24 5:22 PM 2021/9/24 5:22 PM