8. Move throttle lever t o"Fast" p osition ( A), s hown a sa
rabbit.
Tostart t heengine for
the very first time:
9.
Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
9.
Press primer bulb firmly 3 times, waiting 2 seconds
between each push. For a warm engine, DONOT press
primer bulb.
IMPORTANT:Before starting the pressure washer, be sure
/ou are wearing adequatesafety goggles.
WARHIHG
Risk of eye injury.
_Spray
can splash back or propel objects.
Alwayswearsafetygoggleswhenusingthis equipment o r in
vicinity of whereequipment i s in use.
Beforestartingthe pressure washer,be sureyou are wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
10. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
WARHIHG
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
_
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
* NEVER pull startercord withoutfirst relievingspraygun
pressure.
Whenstartingengine,pull cord slowlyuntil resistance is felt
andthen pull rapidlyto avoidkickback.
After eachstartingattempt,whereengine fails to run, always
pointspraygun in safedirectionandsqueeze spraygun trigger
to release high pressure.Engage spraygun triggerlock.
Firmlygraspspraygunwith both handswhenusing high
pressure sprayto avoidinjury whenspraygun kicks back.
11. Return recoil starter slowly. DO NOT let rope "snap
back" against starter.
NOTE:Always keepthe throttle lever in the "Fast" position
when operating the pressure washer.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
,p_
underlying tissues, leading to serious injury and
)ossible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
, DONOTallowCHILDREN to operatepressure washer.
• Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
• NEVER aim spraygun at people,animals,or plants.
, DONOTsecurespraygun in openposition.
• DONOTleavespraygun unattended while machine is running.
, NEVER usea spraygun whichdoesnot havea triggerlock or
triggerguardin placeandin workingorder.
• Alwaysbe certainspraygun,nozzles and accessories are
correctlyattached.
WARHIHG
_
Contact with muffler
result in serious
area can
burns.
,_
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
DONOT touch hot partsand AVOID hot exhaustgases.
* Allowequipment t o cool beforetouching.
Keepat least5 feet (152cm) of clearance on all sidesof
pressure washerincludingoverhead.
* Codeof Federal R egulation (CFR) T itle 36 Parks,Forests,and
PublicPropertyrequireequipment p oweredby an internal
combustionengine to havea sparkarrester,maintained in
effectiveworkingorder,complyingto USDA Forestservice
standard 51BB-1C or later revision.Inthe Stateof California a
sparkarresteris requiredundersection4442 of the California
Publicresources code.Otherstatesmay havesimilarlaws.