Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Hose and Water Supply to Pump
NOTICE
I DO NOT run the pump without the water supply connected
_nd turned on. ______
I* Damage to equipment r esultingfrom failureto follow this
h instructionwill void warranty.
NOTE:Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses•
1.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand•
WARHIHG
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
_ossibleamputation•
NEVER connecthigh pressurehoseto nozzle extension.
• Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized•
• Alwaysbecertainspraygun,nozzles and accessories are
correctlyattached•
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
Beforeconnecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged•DO NOTrun pressurewasher if
inlet screenis damagedor missing.
4.
Run water through garden hose for 30 seconds to flush
it of debris• Turn off water•
IMPORTANT:DO NOT siphon standing water for the water
supply• Use ONLYcold water (less than IO0°F).
5.
Connectgarden hose (not to exceed 50 feet in length) to
water inlet• Tighten by hand•
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
uj_&_j?_ inlet can cause um or inlet connector duma e.
ThereMUSTbe at leastten feet of unrestricted gardenhose
between thepressurewasherinletand anydevice,suchas a
vacuumbreakeror checkvalve•
Damage to equipment r esultingfrom failureto followthis
instructionwill void warranty•
6.
Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities•
WARHIHG
Risk of eye injury•
• _
ISpray can splash back or propel objects•
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles•
NEVER substitutesafetyglassesfor safetygoggles•
ChecMist Before Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1.
Be sure to read Safety Rules and Operationsections
before using the pressure washer•
2.
Make sure handle is in place and secure•
3.
Checkthat oil has been added to proper level in engine
crankcase•
4.
Add proper fuel to fuel tank•
5.
Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose•
6.
Provide proper water supply (not to exceed IO0°F).
Publicidad
Tabla de contenido
