Monster Group WORKBENCH WITH DRAWER Manual De Instrucciones página 7

26115/26462/26463 - WORKBENCH WITH DRAWER
USER GUIDE
ASSEMBLY INSTRUCTIONS
STEP 4:
Fit the 4 Long Worktop Supports (G) to the
Front and Back Legs (A, B, C) at the 1st/2nd
and 5th/6th slots.
The Long Worktop Support with the central
hole should be positioned between the
1st/2nd slots on the Back Legs (B, C).
STEP 5:
Bend the tabs on each end of the Support Bars (S5) to a 90° angle. Locate the slots at the
top and bottom and slot into place between the Front & Rear Side Beams (G).
Bend the tabs back on themselves (as shown below) to attach.
Ensure the
Bend
tabs are
Slide
to
in folded as
180°
shown
Fit the Left and Right Upper Vertical
Supports (H, I) into the sides of the Back
Legs (B, C).
Secure using 4 Short Fixings (V).
Tighten with a suitable spanner to secure.
Secure the Support Bars (S5) into place
using (W).
07