Publicidad
Step 7
Fasten six ANGLE BRACKETS (5G) to the UPPER ENDS (A and B).
å
Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten the END MOLDINGS (Q) to the UPPER ENDS (A and B). Use
å
six BLACK 9/16" LARGE HEAD SCREWS (1S) through the ANGLE
BRACKETS on the UPPER ENDS and into the END MOLDINGS.
NOTE: There are no pre-drilled holes in the END MOLDINGS. The
å
SCREWS will tighten into the grooves.
Angled edge
Groove
www.sauder.com/services
BLACK 9/16" LARGE HEAD SCREW
(12 used in this step)
Q
418734
Don't worry. It isn't
Rome. This can be built
in a day.
1S
B
Groove
5G
(6 used)
Q
A
5G
Angled edge
Page 11
Publicidad
