Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Remove the hose by removing
the hose clamp. NOTE: The hose
clamp is not reusable. You must
purchase a new hose clamp, see
the Parts List or purchase a stan-
dard hose clamp at a local hard-
ware store.
Hose Clamp
5.
Remove pump mounting screws
securing pump (one on each side).
Pump Mounting Screw
6.
Carefully slide pump from
brackets and out of the way.
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2.
Set the On/Off switch to "Off" and
unplug unit.
3.
Turn the regulator counterclock-
wise and set the outlet pressure to
zero.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately 20
psi. Release safety valve ring.
6.
Drain water from air tank by open-
ing drain valve on bottom of tank.
1000002204
Regulator
Manifold
STORAGE
16 - ENG
7.
Using an adjustable wrench or
5/8" wrench remove the regulator
manifold.
8.
Apply pipe sealant to new regula-
tor manifold and assemble, tighten
with wrench.
9.
Reapply pipe sealant to gauges,
quick connect, and safety valve.
10. Reassemble all components in
reverse order of removal. Make
sure to orient gauges to read cor-
rectly and use wrenches to tighten
all components.
in the air tank. If not drained, water
will corrode and weaken the air tank
causing a risk of air tank rupture.
7.
After the water has been drained,
close drain valve by turning clock-
wise.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, then
reinstalled.
8.
Protect the electrical cord and air
hose from damage (such as being
stepped on or run over). Wind
them loosely around the com-
pressor handle.
9.
Store the air compressor in a
clean and dry location.
Pump shown
moved out of
the way
Regulator
Manifold
Risk of Bursting.
Water will condense
Publicidad
