Pur Line VENTY IND 160 Manual De Instrucciones página 9

ASSEMBLY
axle cap nut
wheel
axle rod
bracket
screws
wheel
axle cap nut
fan
body
tubes
screws
fan
support
OPERATION
1. Adjusting the air flow speed
By turning the speed switch, the fan can be set to operate at 3 different speeds: low, medium, high.
2. Angle adjustment
The vertical angle can be adjusted manually.
The fan must be switched off before changing the angle.
CLEANING AND MAINTENANCE
· Unplug the appliance before cleaning.
· Use a soft cloth to clean the appliance. Do not use solvents or harsh chemicals. Never use direct
water.
· Do not clean with metal sourcing pads. It may scratch the surface or cause electrical shock.
END OF SEASON STORAGE
Switch off and unplug the unit.
It is recommended to store the unit in it's original carton. Do not stack heavy objects on top of the
unit.
EN
MOUNTING THE SUPPORT
1. Remove all the contents from the packaging.
2. Fit the mounting bracket.
3. Install two screws through the bottom of the
foot using a Phillips head screwdriver.
4. Slide the shaft rod through the mounting
bracket.
5. Install the two wheels onto the axle rod and
secure with two axle cap nuts.
6. Fit connecting rod, install the two bolts.
MAIN BODY ASSEMBLY
1. Place the stand on the ground with the wheels
on the left side in front of you.
2. Holding the main body, put the tubes on
each side of the bracket, make sure the correct
position of the hole. Then install the screws.
7