Troubleshootmng - Troy-Bilt 030237 Instrucciones De Uso

TROUBLESHOOTmNG
Problem
No AC output is avaimabme, but
generator is running.
Generator
runs
good at no=load
but "bogs" down" when loads are
connected.
Generator wHm not start; or starts
and runs rough.
Cause
H. One of the circuit breakers is
open.
2. FauHt in generator.
3. Poor connection or defective cord
set.
4. Connected device is bad.
I. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
I. 10Amp in=line fuse is blown.
2. Discharged battery.
Correction
I. Reset circuit breaker.
2, ContactAuthorized service facility,
3, Check and repain
3. Failed battery.
Generator shuts down during Out of gasoline.
operation.
Generator lacks power. Load is too high. See "Don't Overload Generator".
4. Connect another device that is in
good condition.
I. Disconnect shorted electrical load.
2.
See "Don't
Overload Generator".
3. ContactAuthorized service facility.
I. Replace fuse.
2. Jump start generator and/or charge
battery.
3. Replace battery.
Fi[[ fuel tank.