Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
BEFORE
STARTmNG THE
ENGmNE
Add
Engine
Oil
* Placegenerator on a [eve[ surface.
1
Refer to engine manualfor oil fill information,
Damage to equipment resuking from failure to follow this
instruction
will
void
warrant><
° Refer to engine owner's manual and follow oil
recommendations
and instructions.
NOTE:
Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE:The
generator
assembly rotates on a prehbricated
and sealed ball bearing
that requires
no additional
lubrication
for the life of the bearing.
Add
Fuel
NOTE:This
gasoline
engine is certified
to operate
on
gasoline. Exhaust
Emission Control
System: EP1 (Engine
Plodifications).
WHEN
ADDING
FUEL
Turn generator OFF
and
let it cool
at least
:Z minutes
before
removing fuel cap. Loosen cap slowly to relieve pressure in tank.
Fill fuel tank outdoors,
DO NOT overfill tank, AIIow spacefor fuel expansiom
Keep fuel away from sparks,open flames, pilot lights, heat, and
other ignition sources,
DO NOT light a cigarette or smoke,
I.
Use clean, fresh, regular
UNLEADED
fuel with a
minimum
of 85 octane.
DO NOT use fuel which
contains
Hethanol.
DO NOT mix oil with fuel.
:2.
Clean area around
fuel fill cap, remove
cap.
3.
Slowly add regular unleaded
fuel to fuel tank. Be careful
not to overfill.Allow
about
:2.:25" of tank space for fuel
expansion
(Figure :2).
INNNNNNNNNNNNNNN
_NNNNNNNNNNNNNN?
INNNNNNNNNNNNNNN
Replace 'q.5" with '2.25"
fuel fill level given in engine manual.
Failure to follow this instruction
may cause fuel to overexpand
and spill from tank.
Install
fuel cap and wipe
up any spilled
fuel.
Remove
Cover
on Start
Switch
A protective
plastic cover is placed over the start switch to
prevent
the generator
from being started.
. Open
cap on battery
float charger.
. Remove and discard
plastic cover over the start switch
(Figure 3).
Replace
cap on battery
float
charger.
Publicidad
Tabla de contenido
