Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation____________________________________
Before beginning assembly or operation of this product, make sure all parts are present. Compare
parts with package contents list and figures above. If any part is missing or damaged, do not
attempt to assemble or operate this product. Contact customer service at 1-877-670-7200, 8:30
am to 6:00 pm EST, Monday to Friday for replacement parts.
Estimated assembly time:
Tools required for assembly:
Helpful tools:
Assembly Instructions___________________________
1. Mixer Frame Assembly
Note: Fasteners should only be tightened
after final alignment is achieved. All
components are referenced in package
components list.
1A) Refer to Figure 1
Assemble rear legs (B) onto pivot pin (D).
Ensure flat sides are facing in. Assemble
front legs (C) onto pivot pin (D). Legs
should be angled outwards. Assemble
spacers (II) onto pivot pin (D) and secure
in place with cotter pins (LL).
1B) Refer to Figure 1
Attach lower frame support (E) to front
legs (C ) using 2 M8 X 50mm bolts (CC)
and 2 M8 flange nuts (AA). Attach lower
frame support (E) to rear legs (B) using 2
M8 X 75mm bolts (BB) and 2 M8 flange
nuts (AA).
DO NOT TIGHTEN!
20 minutes
Adjustable wrench
Pliers
15mm socket or wrench
13mm socket or wrench
10mm socket or wrench
1C) Refer to Figure 1
Attach rear leg cross member (F) to rear legs
(B) using 4 M8 X 50mm bolts (CC) and 4 M8
flange nuts (AA). Slide end caps (EE) onto
rear leg cross member (F).
DO NOT TIGHTEN!
FIGURE 1
5
FIGURE 1
Publicidad
