Publicidad
Idiomas disponibles
Idiomas disponibles
EN
PARAMETERS MODE
List of parameters can be adjusted: DC output mode, battery technology (cf. page 3), Timer 1 & Timer 2,
Low voltage disconnect and high voltage reconnect.
You can enter in parameter mode by pressing
DC CONTROLLED OUTPUT
The DC controlled output is regulated by electronic switch (on positive pole) that can switch ON or OFF
the consumers (light, pump, ...) of your installation.
The maximum current accepted is 10A for UNIMPPT 60/10.24 L, 20A for UNIMPPT 60/20.24 L, 30A for
UNIMPPT 100/30.24 L and 40A for UNIMPPT 100/40.24 L. Output Voltage depends on the battery
connected (12 or 24V).
UNIMPPT L range offers 3 modes for the DC ouput: Manual mode, Night mode, and Sunrise/Sunset Mode
(refer to page 33).
PROTECTION VOLTAGE FOR DC CONTROLLED OUTPUT
UNIMPPT L integrates a DC controlled ouput to protect your battery by controlling the voltage.
DC output switches off automatically if the battery voltage is lower than 11,8V or 23,6V and switches on
automatically if battery voltage increases around 13,0V or 26,0V (default setting).
This DC output is a real protection for your battery cycle life time. Please find below the table showing the
quality of protection depending on your voltage choice.
QUALITY OF YOUR BATTERY
PROTECTION
DISCONNECTION VOLTAGE
Bat 12V : 11 to 12,4V / Bat 24V : 22 to 24,8V
RECONNECTION VOTLAGE
Bat 12V : 12 to 13,1V / Bat 24V : 24 to 26,2V
Disconnection voltage can be adjusted from 11V to 12,4V and Reconnection voltage can be adjusted from
12V to 13,1V. For disconnection, voltage must me under disconnection voltage during 5 secondes.
Reconnection is instantaneous.
Do not connect any DC-AC inverter.
!
Damage not covered by the warranty.
32
5 seconds.
*
**
11,1 V
11,3 V
22,2 V
22,6 V
12,0 V
12,6 V
24,0 V
25,2 V
www.uniteck.fr
***
****
11,5 V
11,8 V
23,0V
23,6 V
12,8 V
13,0 V
25,6 V
26,0 V
****
12,2 V
24,4 V
13,1 V
26,2 V
Publicidad
