Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the Remote Controller
5.12 Cooling Only/Cooling and Heating Selection
Operations
1) In Cooling Only mode, press
Heating function. (see Figure 3.18)
2) In Cooling and Heating mode, press
Only function.
Note:
• Factory default setting is Cooling and Heating mode.
5.13 Auxiliary Heater Operations (reserved)
1) In Heating Mode, Press the button
the screen will display the icon "
indoor unit ;
2) Press
"
", the signal is sent to the indoor unit.
3)Press
"
".
again, and the screen will display the lock icon
a third time, and the screen will display the icon
to turn on the Cooling and
Figure 3.18
", the signal is sent to the
Figure 3.19
19
to turn on the Cooling
(see Figure 3.19), and
Publicidad
