GreenWorks GD40CS15 Manual Del Usuario página 8

IMPORTANT
Use guide bar and chain oil that is only for chains and
chain oilers.
NOTE
The machine comes from the factory without guide bar
and chain oil.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
enters in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. Check the level of oil from time to time.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage
can occur to the guide bar or saw chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 3-7.
1. Remove the chain cover nuts with the wrench.
2. Remove the chain cover.
3. Put the chain drive links into the bar groove.
4. Put the chain cutters in the direction of the chain
operation.
5. Put the chain in position and make sure that the
loop is behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket.
8. Make sure the chain tension pin hole on the guide
bar fits correctly with the bolt.
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the nuts when the chain is well tensioned.
NOTE
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after the
first use, examine the tension and tighten the chain if
necessary.
3.4 INSTALL THE BATTERY PACK
Figure 2.
English
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
Figure 1.
1. Examine the oil level of the machine from the oil
indicator.
2. Add more oil if it is necessary.
4.2 HOLD THE MACHINE
Figure 8.
1. Hold the chainsaw with one hand at the rear handle
and with the other hand at the front handle. Always
use both hands when using the machine.
2. Hold the handles with the thumbs and the fingers
around them.
3. Make sure that the thumb of the hand that holds the
front handle is below the handle.
4.3 START THE MACHINE
Figure 1.
5
WARNING
NOTE
IMPORTANT
NOTE
EN