Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 18 Monday, January 16, 2023 5:19 PM
18 INSTALLATION
CAUTION
• The front leveling legs are extended below the front rollers to improve stability during placement. Once
the unit is placed in front of the opening, completely retract the front leveling legs to allow the unit to be
rolled into position. Front and rear leveling legs can be adjusted from the front once the unit is
positioned.
• If the unit has been on its back or side, it must stand upright for a minimum of 24 hours before turning
on the power.
• After the appliance is rolled into position, verify that the anti-tip brackets are properly engaged.
1
Remove the base panel.
2
Retract the leveling legs so the appliance can be wheeled forward.
3
Plug the power cord into the outlet.
4
If needed, install the water line to the house water supply. See Connecting Refrigerator to Water
Supply for more details. Push the water line through the hole at the front of the appliance until it
emerges from the hole at the rear of the appliance.
5
Tie a long string around the middle of the power cord. Feed the string over the top of the appliance,
pull it until the power cord is held high off the ground, then tape the string to the front of the
appliance to hold the power cord off the ground. Do not pinch or strain the power cord. Make sure it
is still plugged in.
6
Carefully move the appliance into the enclosure, making sure not to pinch the power cord or water
line under or behind the appliance.
7
Remove the string from the power cord and the edge protection from the enclosure.
Publicidad
