Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 8 Monday, January 16, 2023 5:19 PM
8
BEFORE INSTALLATION
-
Cutout Dimension
F
(Electrical
outlet)
G
(water supply)
NOTE
• Refrigerator can be installed flush or proud (B).
- Flush: With a 25" (635 mm) cutout depth, the
front face of the freezer fits flush with 25" (635
mm) depth adjacent cabinets.
- Proud: With a 24" (610 mm) depth cutout, the
front face of the freezer extends
approximately 3/4" (19 mm) beyond 24" (610
mm) depth adjacent cabinets.
• A minimum 4" (102 mm) finished return (D) that
matches the cabinet exterior is recommended
on all sides and the top of the cutout opening.
The shaded area will be visible after installation.
Electrical
• A 115 V, 60 Hz, 15 amp power supply is required.
An individual, properly grounded branch circuit
or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• When installing a single product, use a single
outlet.
NOTE
• GFCI (ground fault circuit interrupter) is not
recommended.
Water Line
• A cold water supply is required for automatic
icemaker operation.
• The water pressure must be between 20 and 120
psi.
• Tubing should be long enough to extend to the
front of the refrigerator. Allow enough tubing to
accommodate a bend leading into the water line
connection.
• Water line can enter an opening through the
floor or back wall.
• Install a shut-off valve between the refrigerator
water valve and the cold water supply in the
home.
4" (102 mm)
5" (127 mm)
Installation Clearances
Top View
* Door handle must be added to this dimension.
** Varies depending on the thickness of the
custom cabinet panel. 3/4" (19 mm) is correct
dimension when using the Stainless Steel Door
Panel Kit (optional accessory).
-
Dimensions and Clearances
A
47 1/2" (1206.5 mm)
B
47 1/4" (1200 mm)
C
24" (610 mm)
D
1/8" (3 mm)
2
E
11 1/2" (292 mm)
F
23 1/2" (596.5 mm)
G
25 3/8" (644.5 mm)
H
3/4" (19 mm)
NOTE
• Door Swing Clearances
- The installation must allow for clearances to
adjacent walls or cabinets. This refrigerator is
equipped with a 2-position door stop. The
factory-set 115° door swing can be adjusted to
90° if clearance to adjacent cabinets or walls is
restricted.
Publicidad
