Descargar Imprimir esta página

Costan Cayman UP Instrucciones De Uso página 60

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
9.8
Use of cabinet
L
Regulation of the tension of the closing
spring of the door. If necessary, increase
the tension of the return spring, carry
out the operations of the "Fig. 21".
Lighting
The cabinet lighting is controlled by a switch on
the bottom right of the cabinet.
Thermostat/thermometer
A
remote
thermostat/thermometer
positioned on the bottom right of the cabinet to
control the temperature. "("Fig. 2").
The remote thermostat displays the existing
temperature inside the housing and the
temperature is controlled using the dedicated
buttons.
F
Never leave upper glass sliders open or
ajar. It is advisable to often check that
all sliders are closed: you will thus avoid
unnecessary energy consumption and
frost build-ups on the walls and you will
also allow better foods preservation.
N°DOC. QUM000129A REV. "D" - 25/01/22
CAYMAN UP
Epta Spa - Via Mecenate, 86 - 20138 Milano (MI) ITALIA
Tel. 02/55403211 Telefax 02/55401023
9.9
Cleaning and ordinary
maintenance
Good visibility in the intervention area is
recommended, possibly using an additional
light source.
L
Anti-fogging coating of the doors LOW
CONSUMPTION. The doors of the
cabinet have an anti-fogging coating
which prevents the formation of fog in
any
humidity,
is
immersions
cleaning. Extremely hydrophilic, the
coating produces drops of water which
propagate and do not, therefore, turn
into
humidity, the coating does not melt in
water and, consequently, is not stained
if wet. The film is not damaged by
commercial detergents for glass, stain
removers, ammonia, alcohol and petrol
and does not discolour when exposed to
sun or heat.
The doors are provided with laminated anti-
fogging coating on the inner glass and protected
by a layer.
The protective layer is partially raised on the
sides to facilitate its removal during use. The
protective layer must be removed after the
doors have been installed on the cabinet once
the
cabinet
temperature. This is to allow immediate
operation of the anti-fogging film.
To recall this passage, the following label is
attached to the protective film: " DO NOT
REMOVE THE PROTECTIVE FILM UNTIL THE
CABINET HAS REACHED THE OPERATING
TEMPERATURE".
temperature
condition
even
after
in
water
or
fog.
Though
absorbing
has
reached
the
17/21
IT
FR
EN
EN
DE
ES
and
PT
prolonged
frequent
the
operating

Publicidad

loading