Shark D-SKWAL 3 Manual Del Usuario página 12

5 - Make sure that the entire silicone
seal of the lens is adhered to the visor,
otherwise adjust the tension of the lens
using the external adjustment levers and
a coin.
MIN
6 – Turn the 2 levers outwards to increase
the tension of the lens (rotate towards
«MAX»).
7 - Remove the protective film from the
PINLOCK® lens before reinstalling the
visor on the helmet.
WARNING! The protective film
may alter the quality of your field
of view if it is not removed.
12
5
MAX
6
7
MAINTAINING THE PINLOCK®
Clean the lens using mild liquid soap,
lukewarm water and a soft damp rag only.
Allow the lens to dry naturally before
reassembling it.
WARNING! Do not use abrasive
cleaning agents, liquids containing
ammonia or alcohol.
If your PINLOCK® lens no longer pro-
vides excellent visibility after a period
of use, it must be replaced without fail.
ASSEMBLING THE VISOR
1 – Locate the visor notch system on each
of the side plates of the visor mechanism.
1