Shark D-SKWAL 3 Manual Del Usuario página 21

3 - Un-clip the front part of the comfort
liner, clip by clip, by pulling inwards starting
from either of the two ends.
4 - The comfort liner is completely
detached and can now be removed.
ASSEMBLING THE INTERIOR
3
1 - Slide the comfort liner into the helmet.
Check that it has been reinserted the right
way around. Reposition the front of the
comfort liner. Clip the five clips into their
slots. Start with the middle clip which
must be slid over the arrow shown on the
comfort liner support, then one by one the
next four side clips.
4
2 - Put back the rear of the inner lining.
1
2
21