Erbauer ETBV18-Li Manual De Instrucciones página 19

02
Battery pack 02 (Fig. A, B, C)
WARNING! Make sure that the on/off switch (2) is in "O" position (refer
to Controls - On/off switch).
Attaching / removing the battery pack (not supplied)
1. Unlock both upper cover latches (3) (Fig. A, step 1) and open the upper cover (7)
(Fig. A, step 2).
2. Align the sliding slots of the battery pack with the battery docking port (8) and slide
the battery pack in to attach it. Ensure it clicks in place (Fig. B).
3. To remove the battery pack, press down the release button (Fig. C, step 1) and pull
out the battery pack from the battery docking port (8) (Fig. C, step 2).
03
Hose and nozzles (Fig. D, E, F, G, H)
The hose (13) is pre-assembled on the suction port (6a) for vacuuming.
Removing:
1. Rotate the locking ring (13a) anti-clockwise to unlock the hose (13) (Fig. D, step 1).
2. Remove the hose from the suction port (6a) (Fig. D, step 2).
Assembling for vacuuming:
1. Place the locking ring (13a) into the suction port (6a) (Fig. E, step 1). Rotate the
locking ring slightly to ensure its locating pin (13b) sits properly.
2. Rotate the locking ring (13a) clockwise to lock the hose (13) (Fig. E, step 2).
3. Place the hose (13) through the hose port (6), close the upper cover and secure it
with cover latches (3) (Fig. F).
4. Connect the required nozzle (9, 10) onto the hose connector (13c) (Fig. G).
Assembling for blowing:
1. Place the locking ring (13a) into the blower port (12) (Fig. H, step 1). Rotate the
locking ring slightly to ensure its locating pin (13b) sits properly.
2. Rotate the locking ring (13a) clockwise to lock the hose (13) (Fig. H, step 2).
04
Cartridge filter (Fig. I, J, K)
This product is designed for dry and wet vacuuming as well as blowing.
The cartridge filter (11a) arrives assembled on the motor unit (11) and can be replaced
with a new filter when necessary.
MNL_ERBAUER_18 V vacuum cleaner_ETBV18-Li_IMGB_V1_220127.indd 19
19
1/27/22 3:45 PM