Asist AE9CPK90 Instrucciones De Uso página 38

ADDITIONAL SAFETY INSTRUCTIONS
Please read these safety instructions before use and
keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The electric submersible pump complies with the
applicable technical regulations and standards.
- This appliance is not intended for use by children
under 18 years of age or older and by persons with
reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, provided they
have been given supervision and instruction con-
cerning use of the appliance in a safe manner and
understand the risks involved. Children must not play
with this device. Cleaning and user maintenance must
not be performed by children without supervision.
- Only qualified electricians may carry out electrical
installations on the device.
- Do not use the device in potentially explosive areas
or near flammable liquids or gases.
- Check mains voltage. The data marked on the type
plate must correspond to the technical data of the
mains supply.
- The device may only be connected to a grounded
socket that is equipped with a residual current circuit
breaker (30 mA).
- Do not tangle, step on, handle or otherwise handle
the cord, or protect it from being crushed or crushed.
Protect the cord and plug from heat, oil and sharp
edges.
- Do not touch the mains plug with wet hands. Always
disconnect the plug by pulling on the plug, not the
cord.
- Extension cords must not be used.
- Disconnect the mains plug before carrying out any
work on the device.
- The temperature of the pumped liquid must not
exceed 35 ° C.
- The pump must never run idle.
- When used in swimming pools, outdoor heated
pools, etc., the pump must not be started if there are
people in the water.
- Protect the device from frost.
- Repairs must only be carried out by a qualified
electrician. If repairs are made incorrectly, there is a
risk of liquid entering the electrical components of the
device.
- Follow all safety instructions. Failure to follow these
instructions may result in harm to you or others.
ELECTRIC SHOCK
! If you use the device by a swimming pool, garden
pond or similar reservoirs, you need to install an addi-
tional switch to protect against electric shock. Keep
this switch in working order to ensure the safety and
reliability of the device.
! The electrician responsible for installation must
check that the electrical connection and the earth
terminal comply with the electrical regulations.
! This device may only be used if it is connected to an
el. circuit with a 30 mA RCD.
! The device has a power cord with a plug with a
safety pin. The electrical outlet must be grounded.
Defects caused by a short circuit in the supply are not
covered by the warranty!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION ( A )
DESCRIPTION
1. Power cord
2. Carrying handle
3. Automatic float switch
4. Float switch cable terminals
5. Hose adapter
6. Outlet
7. Base
Pictograms
Pictograms on the product packaging:
a) Power supply values
b) Power consumption
c) Degree of IP protection
d) Max. particle size
e) Max. fluid temperature
f) Max. flow
g) Max. discharge height
h) Max. immersion depth
f
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Always remove the mains plug from the socket before
working on the device.
Construction
Risk of damage to the device!
Do not lift the pump by the cable or pressure connec-
tion, as neither the cable nor the pressure connection
is dimensioned for the tensile loads of the pump.
38
h
g