Stahlwille MANOSKOP 730D Puesta En Marcha página 28

Short instructions - practical example
• Place the torque wrench on a flat surface.
• Make sure that no forces are acting on the torque wrench.
• Press any button to switch on the torque wrench.
The software version number is shown in the display.
• Press the OK button.
If the "Save values" function is switched on, the four-digit
bolting application number is displayed.
• To confirm the bolting application, press the OK button.
The current torque value which is set is displayed. The "TARA!"
symbol flashes in the display.
The torque wrench is automatically tared within a few seconds.
• To set the torque value, press the F button until the torque
value is displayed. The set torque value flashes.
• Use the arrow buttons to set the torque value to 90.0 N·m.
• Press the F button.
• Use the arrow buttons to set the unit of measurement
to N·m, if necessary.
Attention: Material damage possible due to incorrectly set
values. Make sure that the torque value which is set after
changing the unit of measurement is correct.
• Press the F button.
• Select "On" to set the "Cut-out" function mode
• Press the F button.