SIBRAPE Mini Light 2.0 Manual Del Usuario página 6

Specifications
MODULE OUTPUT
* Mini Light 2.0: 12VDC RGB common anode 60W - 5A
FOR MORE DETAILS, SEE CONNECTION SCHEME - WIRING DIAGRAM.
The LED Light Controller is designed to operate 10 Pool Lights Super LED 6W, 3 Super Pool Lights Super LED 18W,
5 Pool Lights Super LED 12W Stainless steel or 3 Pool Lights Super LED 20W Stainless steel. The reflector wires
should always be driven to a junction box; from there they could be taken directly to the controller. You can also
use a single set of wires to go from the junction box to the controller; in order to do this, it is necessary to connect
the wires with the same colors so that the reflectors are always color synchronized. After connecting the matching
colors, this main cable should be connected to the LED Light Controller. This cable must have a maximum length
of 20 meters and have the following specification: 3x22 AWG (red, green, blue) and 1x16 AWG (white).
Remote Control Registry
The remote control is factory configured for immediate use; it does not need any adjustments.
If it is necessary to replace the control, it must be previously programmed in the controller before using
it, otherwise, it will not work. To register a new Remote Control or reconfigure your Remote Control:
1- With the Reflectors off, press and release the "Effects" + "on/off" keys at the same time. The reflectors will
start to flash white. This will indicate that Mini Light 2.0 has entered remote control programming mode.
2- Press any key on the controller that you want to program. If the reflectors stop blinking, Mini Light 2.0 has recognized
the remote control and that's it, you already have a new remote control ready to command your controller functions.
3- Test all the buttons on the remote control and make sure that they all responded according to the functions of the
model purchased.
ATTENTION! If the buttons do not respond properly, perform the remote control setup procedure:
1- Press again "Effects" + "on/off" at the same time on the Mini Light 2.0 front panel. The reflectors will start
flashing white, re-entering the remote control programming mode.
2- The control configuration is done by the button "Colors". Press until the reflectors flash in the color GREEN.
3- After, Once the control has been set, press the "Effects" + "on/off" again to exit the remote control programming
mode.
Delete all registered controls:
It is possible to delete all control saved, to do this, reset the controller memory:
- Press all the keys on the front of the panel for 3 seconds and wait for the Reflectors flash white twice.
- Turn the controller off and on again. If the first color that lights up when turned on is blue, it means that the reset
was successful.
Operation
The Equipment must be turned on by the On/Off button on the front of the panel or in the remote control.
In fixed colors and effects, you can control the intensity of Shine (dimmer) - Only in the remote control.
In the Remote Control you can Increase "/\" or decrease "\/" the brightness. The first time it's turned on, the
lighting is set to maximum brightness and you can adjust the brightness. When the illumination reaches the
minimum or maximum brightness, the reflector flashes white 2 times to indicate to the user that the reflector has
reached the limit.
Only in the Effects - you can control the speed of the effects - Only in the remote control.
In the Remote Control you can Increase ">>>" or decrease ">" the speed. The first time it's turned on, the lighting
is set to maximum speed and you can adjust the speed. When the illumination reaches the minimum or maximum
6
Installation and User's Guide