Publicidad
Idiomas disponibles
Idiomas disponibles
Auto Colors Test
NOTE: To repeat the test routine, remove the controller from the power, wait a few seconds and turn on
again.
After the test routine, just press the button (ON / OFF) on the remote control, or in the Mini Light 2.0
front panel. The first time it is turned on, Mini Light 2.0 starts from the first effect (see table of effects).
However, every time it is turned off, the color, effect and light intensity are memorized, starting with
these when turned on again.
Wiring diagram
The controller is energized in the 2-way connector - 100-240VAC 50/60Hz.
To connect the controller to the Reflectos, just take a 4-way cable (or 4-way sleeve cable) to the Junction box closest
to the pool, and from there make the connections in parallel. This is to minimize the amount of cables that will
reach the controller.
* The common reflectors output is 12VDC (+) and the RGB outputs will have 0V (-), indicated for reflectors with a
common cable type.
* Electrical protections must be considered in accordance to local regulations. Low voltage electrical installations
must be complied for the safety of users, electrical installations, equipment and animals.
* This equipment is extremely safe because of its direct voltage operation, using low voltage and direct current di-
rectly in the Pool Lights, avoiding electrical discharges or accidents derived from the use of electricity in or around
the swimming pool.
Microphone for audio function - Included
Position the Microphone close to an audio
source (Speaker) and the reflector will blink
to the music in the Microphone function.
If necessary, extend the microphone cable to
take it to a more accessible area.
8
Installation and User's Guide
Eletricity grid
100-240VAC
50/60Hz
Publicidad
