•
Store the unit in a dry, dust- and vibration-free place. Avoid
damage to the unit.
Avoid danger to life by environmental effects
WARNING! Please make sure that the unit is not covered with towels,
curtains or similar objects. Otherwise there is danger of overheating.
Therefore, always pay attention that the ventilation slots 1 are kept
clear.
•Do not operate the unit in rooms in which dampness can develop or
in which it can come in contact with water.
•Do not install the unit directly beneath a wall outlet.
WARNING: in order to avoid overheating, do not cover the heater.
Before operation
ATTENTION! Do not place the unit directly beneath a wall outlet. In
the case of non-observance danger of injury and / or damage to the
unit can result.
ATTENTION! Please pay attention that you do not pinch the power
line and protect it against sharp edges. Damaged power lines increase
the risk of an electric shock.
Note: Make sure that the electric wall heater is correctly installed. In
case of any doubt, please contact a specialist.
Instructions: Please keep in mind that the power cord must also
remain accessible after installation of the electric fireplace.
The product has to be installed on a flat surface with 3 screws. Ensure
that the wall is suitable for mounting the product with the supplied
screws/plugs (the product is supported by 2 screws only. The bottom
screw is meant for securing the product.). When looking for a suitable
location for installing the electric wall heater, take all safety instructions
into account. The product has to be mounted level.
At least 60cm of free space is required at the top of the product and at
least 20cm of free space at left, right and bottom side.
•
Drill the holes (Ø7mm) in the wall according to picture C.
•
Put the plugs in the holes and fix the two upper screws.
•
Mount the heater to the wall by means of the two upper screws.
•
Mount the safety bracket on the back side of the product.
•
Tighten the bottom screw.
•
Put the decoration stones on the brim on the front side of the