Descargar Imprimir esta página

Alpena SEATTLE AJ145-S Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
USING THE THERMOSTAT CONTROL BUTTON
Pressing the thermostat control button(12) to tum on the heating
function.Pressing the thermostat control button(12) again to tum on the
heating function. Continue to press the thermostat button(12) to cycle
through the different heat settings, 17C-18.C-19C-..... -26C-27"C-
ON- OFF. To display the temperature setting in either Fahrenheit or
Celsius, press the thermostat button (12) of control panel once, then
press and hold the power on/off button (11) of the control panel for 5
seconds. The display will switch between Fahrenheit or Celsius.
USING THE TIMER CONTROL BUTTON
Pressing the timer control button (13) will set the timer. This interval
period is shown in the display (8) on the control panel on the side of
the electric fireplace. There are total 8 levels timer settings, from 0.5hr
- 1 hr - 2hr - 3hr - 4hr - 5hr - 6hr - OFF.
USING THE WEEK TIMER CONTROL BUTTON
Note:
Besides a regular timer function, this unit also equipped with week
timer function, to setup the time when to turn on and off the heater
with desired temperature, one group each day and max. 7 days/
group available. if stop pressing any of those buttons for more than 5
seconds, will quite the week timer function and confirm the previous
setting.
Using the timer button(13) on control panel to setup the week
timer
Press and hold the timer button(13) on control panel for 5 seconds
to input current local time(01,02,03, ... 21,22,23) by pressing flame
button(11) or thermostat control button(12), then press timer button(13)
again to confirm previous setup and the digital display will show "1d"
to start setup 1st group and re-press the timer button(13) once and
right after the digital display showing "--" to setup the UNIT-ON-TIMER
by pressing flame button(11) or thermostat control button(12), and
press timer button(13 again and after digital display showing "--"to
setup UNIT-OFF-TIMER by pressing flame button(11) or thermostat
control button(12), then press the timer button(13) once to confirm
the previous settings and after the digital display showing "--" to setup
the temperature desired; and repeat to setup 2d,3d, .. ,7d; to skip a
specified day/group, by continue pressing timer button(13) to select
and setup the timer function o the specified date desired.

Publicidad

loading

Este manual también es adecuado para:

871125217849