product.
•
Mount the glass by using the four pins at the sides of the
product.
•
Insert the power plug 4 into an earthed outlet.
Note: Please observe that the power plug must still be able to be
reached after installation of the electric fireplace insert.
Operation
The voltage of the power source must comply with the specifications
on the name plate of the heater. Devices marked with 230 V can also
be operated with 220 V. Before operation it is imperative to make sure
that the installation location corresponds to the requirements of the
safety instructions.
Note: When the heater is turned on for the first time, a slight, harmless
odour can develop. This odour develops due to the heating up of the
inner heating elements. Provide sufficient ventilation.
This product equipped open window detection function, when the
products detected the room temperature decreased over 3 comparing
to the temperature set within 0.5 hour, the unit will stop providing the
heat and the display screen will show "00".
USING THE MANUAL AND REMOTE CONTROLS
Note:
Before using the fireplace please make sure set the toggle switch(5)
to the position I. Set the toggle switch(5) to the position 0 if you would
like to turn off the unit. On the top-right side plate of the electric
fireplace is the control panel(6). This panel contains the buttons to
properly operate the electric fireplace. The buttons on the control
panel on the side of the electric
fireplace and the remote control function in the same way. The remote
control has an effective range of up to 13 feet.