Publicidad
Idiomas disponibles
Idiomas disponibles
General product maintenance
Do a check of the control ca-
ges, blastwheels and liners for
To do before you
wear. Refer to
operate the product on page
12 .
Do a check of the drive belt ten-
sion.
Do a check of the drive chain
tension of the drive system.
Clean the drive chain of the
drive system.
Do a complete servicing and
cleaning of the product.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the chain of the drive system
1. Remove dirt on the outer surface of the chain with a
hard brush or wire brush.
2. Clean the chain with cleaning agent.
3. Remove dirt from internal parts of the chain.
To remove and install the control cages
1. Remove the feed spouts.
2037 - 001 - 07.02.2023
Each 3 h
Daily
X
X
12 h after
service
2. Remove the cage clamps and the control cages.
3. Install the control cage in opposite sequence.
To remove and install the blastwheels
1. Remove the feed spouts and the control cages.
To remove and install the control cages on
Refer to
page 23 .
Each 3
Yearly
months
X
X
X
O
23
Publicidad
