Atlas Copco ETV STR61-50-B10 Instrucciones Del Producto página 9

ETV STR61-50-B10
Tools from 50 Nm
1. Thread the circlip and the yoke ring onto the tool.
2. Attach the rubber cover onto the motor cover of the tool.
3. Attach the clamp rings on the rubber cover.
NOTICE Make sure the clamp rings are oriented with the flange according to the picture.
4. Hold the tool using a vise and assembly/disassembly tool against the rubber cover.
5. Push the yoke ring onto the clamp rings.
6. Secure the yoke ring with a circlip in the slot of the clamp rings.
EN
© Atlas Copco Industrial Technique AB - 9836 9815 00
Installation
9