Publicidad
Idiomas disponibles
Idiomas disponibles
WEAK OF BASS:
▪ Speakers' cables may be with polaritie
of-phase).
NOISE AND FAILURE IN SOUND:
▪ Make sure that the installation is not close to the vehicle's original wiring,
as it may cause interference and noise in the audio signal.
▪ Make a separate power connection for the sound system. Use a fuses or
circuit breakers as close as possible to the battery for protection.
▪ Make a good grounding for the amplifier. To do this, remove the paint
from the vehicle chassis at the desired point. Attach the wire using a ground
terminal. To prevent oxidation, isolate with paint.
▪ Do not loop with ground using multiple grounds. Prefer the star
connection, with all grounds starting from a single point.
Nominal power based on equipment of Stetsom Laboratory.
Analyzer AMPLIFIER DYNO AD-1 SMD: test reference of frequency 40Hz with THD+N to ≤1%. The
electronic components and the manufacturing process can vary slightly and may cause a slight
variation, even with the same measurements.
Any updates made in this manual will be available for customers to consult free of
charge on the Stetsom website. It is recommended that the updated manual be
consulted whenever needed.
Images contained in this manual are merely illustrative and may differ from the actual product.
and
inverted (speakers out-
9
Publicidad
