Descargar Imprimir esta página

Remington PrecisionPro MB-200 Guía De Uso Y Cuidado página 5

Ocultar thumbs Ver también para PrecisionPro MB-200:

Publicidad

Idiomas disponibles

Idiomas disponibles

27508_MB200/300_IB 8/31/05 4:40 PM Page 8
Trimming Beards
Before you begin, comb your hair in the
direction that it grows so that the hairs
are at their maximum height and facing
in the same direction.
Determine how much hair you want to
cut and position the hair length selector
accordingly. Remember, until you are
familiar with using the trimmer, it's
always better to select a longer hair
setting initially in order not to trim too
much hair.
Turn the unit's power switch to ON, and
begin trimming.
When finished trimming, turn the unit's
power switch to OFF.
To Trim the Beard's Hair
Length
Trimmer guard attachment is on.
Turn the trimmer so the front of the
cutting unit ("Zoom Wheel" side) is
facing away from you.
Start trimming under your chin and,
following your jawbone line, work toward
your ear and upper beard line using an
upward motion. Allow the hair length
selector attachment to follow the
contours of your face.
You may trim either
against or with the
direction of beard
growth, whichever
is preferred.
To Define the Beard Line
Remove trimmer guard attachment.
Hold trimmer vertically with cutting
blades facing you.
8
Get user manuals:
See SafeManuals.com
How to Use
Start with edge of beard line. With
the cutting blades resting lightly
against your skin, use
motions towards edge of
beard line to trim it to
desired location in facial
area and away from
beard in neck area.
To Thin and Taper the Beard
Trimmer guard attachment is off.
Use the unit's styling comb or a small
comb and hold the beard hairs in place
while trimming.
Holding the trimmer
hoizontally with the
cutting unit facing away
from you, move
the trimmer along the
length of the comb.
Creating the "Stubble Look"
Trimmer guard attachment should be
on and set to position 1 (1.5 mm) or
2 (2.5 mm).
Hold trimmer horizontaly
with the cutting unit
facing either up or
down.
Trim hairs using an
upward or downward
motion against or with
the direction of hair
growth, whichever
is preferred.
For an even closer
"stubble look," remove
the hair length selector
attachment and repeat
the previous two steps.
However, caution must be taken not
to remove too much hair, creating a
"blotchy" look.
To trim sideburns
To Trim Mustache and
Comb sideburns following the direction
Sideburns
of your hair growth.
with the Pop-Up Trimmer (MB-300)
Be certain trimmer guard attachment
The small size of this trimmer makes edging
is ON.
and defining mustaches and cutting stray
Hold trimmer vertically with front of
hairs quick and easy.
trimmer facing you.
Remove guard attachment
Trim sideburns using a downward
Comb hairs outward so they are at their
motion.
maximum height.
Turn trimmer OFF.
Open the pop-up
trimmer by sliding the
Trimming the Nape of Your
trimmer switch upward.
Neck
Hold trimmer perpendi-
You will need a hand mirror for this
cular, as shown,
operation if performing it alone. The
to achieve desired line
mirror is not necessary if trimming is
above the lip.
performed by a second person.
Trim any stray hairs.
Remove the hair length selector
Attention: Main cutter is
attachment.
still operating while pop-
Use your fingers to lift the hair at the
up trimmer is in use.
base of your head up off the neck. Your
Close trimmer by sliding
index finger should be covering the roots
trimmer switch down.
of the hairs you are lifting to prevent
Turn trimmer OFF.
accidental removal by trimmer.
Using your other hand, hold the trimmer
Without trimmer guard attachment
horizontally to the base of your neck with
Remove trimmer guard attachment.
the cutting unit facing up, and move the
Place a finger on upper lip only to lift
trimmer along the length of the neck until
hair up, away from skin.
the unit touches your finger covering the
Trim hairs using an
hair roots at the base of your head.
upward motion.
Repeat this procedure for the entire area
After achieving desired
of the neck. Be sure to move the unit
length, use a downward
slowly when performing this operation
motion to blend
and to keep the hair roots at the base of
mustache hairs.
your head out of the way
NOTE: Use slow and light pressure. Too
of the trimmer.
much pressure may trim off more hair
Use the hand mirror to
than desired.
inspect the results of the
Turn trimmer off.
operation and ensure all
hairs along the nape of
the neck have been
trimmed.
9

Publicidad

loading

Este manual también es adecuado para:

Precisionpro mb-300