Publicidad
Idiomas disponibles
Idiomas disponibles
and visual alarm in the event of any anomaly. However, for optimum results,
you should ensure the correct hydraulic operation of your swimming pool.
Corrosive environments may reduce the lifespan of the equipment. Do not leave
open containers with acids near the equipment.
2- PREPARING THE SWIMMING POOL
2.1- Adding salt to the water
To ensure that the chlorinator works correctly, a small amount of salt should be
added and the pH level should be suitable.
The recommended salt and pH levels are the following:
pH of the swimming pool water------------------- 7.1 to 7.4
Proportion of SALT in kg/m3-------------- 4 to 6
Although the equipment will start to operate with lower amounts of salt, the
optimum production of salt will be reached with concentrations of over 4kg/m3.
We recommend a concentration of 5Kg/m3 to offset small losses of salt
occurring when cleaning the filter, the effect of rainfall, etc.
To calculate the salt to be added, multiply the total m3 of your swimming pool x
5.
A swimming pool measuring 9m in length x 4.5m in width x 1.6m in
Example :
depth.
9 x 4.5 x 1.6= 64.8 cubic metres. 64.8 x 5 = 324 Kg of salt to be added.
We recommend using salt that is especially prepared for use in salt water
chlorination installations,
as it is especially prepared for rapid dissolution and
to achieve optimum results. You can find it at retailers specializing in swimming
pool products.
ATTENTION
When adding salt to the swimming pool, first disconnect the
chlorinator (position OFF), and start-up the filter for 3 or 4 hours, in
order for the salt to dissolve and not to overload the equipment. Once
dissolved, start-up the chlorinator.
It is advisable to add salt to the swimming pool gradually, in 2 or 3 times so as
not to exceed the recommended amount. Excess salt can overload the
chlorinator, in which case it will automatically stop working and water will have
to be added to reduce the concentration.
We also recommend not to add salt near the drain, to avoid undissolved salt
from circulating in the water circuit.
31 / 53
Manual PRO200V2 V2
Publicidad
