BSV PRO200V2 Manual De Usuario página 52

"SHORT CIRCUIT"
"OPEN CIRCUIT"
"Chlorine Alarm"
"pH Alarm"
4.3- Working hours
It may be useful to see the operation times for regular maintenance operations.
From the main screen, press both buttons   at the same time.
5- WARRANTY AND SERVICE
BSV Electronic S.L. guarantees its BSPOOL equipment for a period of 3 years in
control centres.
Manual PRO200V2 V2
The flow switch is wrongly
connected or damaged
No water flow
The cell is incorrectly
connected.
Metal body in the cell.
Cell is incorrectly connected.
Cell is damaged
completely worn down.
Swimming pool water with
very low salt concentration.
Chlorine probe is incorrectly
connected or damaged
Water contains very
redox potential.
The equipment does
have a probe and is in
"automatic mode".
Empty dosing tank
pH pump problem
Probe or cable damaged
Check that the
correctly connected
properly.
Check the hydraulic installation.
Check wiring.
Turn off the equipment and remove
the metal body from the plates
Check the cell
ensure that cables and connection
terminals are in good condition.
or Check the condition of the cell
electrodes, and replace it if any
damage is observed.
Ensure that the water has salt and
that it is dissolved.
Check the cabling of the probe and
the probe itself. Check 5.1.
It can work in manual mode if
necessary.
low Leave the equipment to chlorate in
manual mode for at least 2 hours.
Check the chemical balance of the
water. (appendix 1)
not Install a Redox or Free Chlorine
probe, or configure "manual" mode.
Fill up dosing tank
Check wiring connections
Put it into pattern liquid. Check if
probe is working
flow switch is
and works
connection and
52 / 53