Andis TS-1 Instrucciones De Uso Y Cuidado página 5

the carton. Plug the adapter into a 100-240V AC outlet, or according to your local
power standards. Note that the shaver ON/OFF switch must be in the OFF position
for the battery to charge. Plug the cord adapter directly into the inlet on bottom of
shaver (Figure A). The green charging indicator light on the shaver will turn on. After
battery is fully charged, the green charging indicator light will turn off.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord is plugged firmly into shaver. Twist the adapter
connector slightly to insure good electrical connection. If failure to charge still
exists while product is under warranty, return shaver to Andis for examination and/
or replacement.
USE WITH CORD ADAPTER
If the shaver powers OFF while in use, the power cord can be attached to continue
use in corded operation (Figure A). When the shaver is running with the power cord
attached, the green charging indicator light will remain off, even if the battery is
partially or fully discharged. The shaver will not charge while in use with the cord
attached.
This power unit is intended to be correctly orientated in a vertical or floor mount
position.
FOR SHAVING
1. Keep the unit clean and dry at all times.
2. Remove the protective plastic headguard.
3. Check to make sure the outer foils and inner cutters are not damaged. Replace
damaged parts before using. For more information on replacement parts, contact
Andis or the nearest Andis authorized service station.
4. Ensure that the battery is charged.
5. Wash and dry your skin thoroughly prior to shaving.
6. Slide the ON/OFF switch up to the ON position.
7. Gently stretch the skin of your face with your free hand while moving the shaver
slowly and smoothly against the grain of your beard. Using short, circular strokes
will make the hairs stand out from your face and make shaving easier. Hold the
shaver at a 90 degree angle to your face while maintaining contact with the foil.
8. In order to achieve the closest shave and avoid unnecessary wear on the foils, be
sure that both foils contact the skin simultaneously at all times. Holding the shaver
5