Andis TS-1 Instrucciones De Uso Y Cuidado página 6

at an angle where only one foil contacts the skin will cause distortion of the foil
and may result in skin irritation.
9. To facilitate cutting and avoid foil wear, use minimal pressure to apply the shaver
to your skin.
10. To maximize shaving comfort, be sure to clean the shaver thoroughly after use.
USER MAINTENANCE
If shaver is to remain unused for a long period of time, store in a safe, cool, dry
place. Do not wrap cord tightly around shaver. Do not hang the shaver by the power
cord. Other than the recommended maintenance described in this manual, no
other maintenance should be performed. To contact Andis directly, please call our
Customer Support Team at 1-800-558-9441 or email us at support@andisco.com.
IMPORTANT: For best shaver performance and results, it is recommended that you
replace your shaver's foil assembly and cutters every six months.
TO REPLACE FOIL ASSEMBLY
1. Remove the foil assembly by pressing the round assembly lock button located on
the right side of the shaver. Grasp the foil assembly on both sides and gently lift it
off the shaver (Figure B).
2. Position the replacement foil assembly over the cutters. Be careful not to damage
the foils. Gently slide the foil assembly down until it snaps firmly into place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure C).
2. To replace a cutter, hold it on both sides and line up the small metal shaft on its
underside with the notch on the shaver drive and push down firmly until it snaps
into place.
3. Replace foil assembly.
CLEANING
Regular cleaning is necessary in order to maintain the optimal performance and
maximum comfort from your shaver. Do NOT run shaver, foil assembly or cutters
under water. Use only the small brush (included) to clean.
6