Varex Imaging XRpad2 HWC-M Digital X-ray Manual De Usuario página 48

XRpad2 HWC-M Detectors User Manual
Table 11 includes the specification for the battery pack.
Table 11 Specifications of the Battery Packs
General
REF
Voltage
Amp-hours
Capacity
Charging Time
Environmental
Relative Humidity
Operating (discharging)
Charging
Transportation
Storage (up to 3 months)
Ingress
Ingress Protection Rating
Lifetime
Charge-discharge Cycles
13.2 Charging the Battery Pack
The new battery pack comes in a discharged condition and must be charged using the
1
dedicated battery charger before use. Refer to the battery charger instruction for use (IFU),
included with the battery, for more information.
The battery charger will charge the battery pack to a usable condition within three hours
2
depending on the initial state of charge. The X-ray detector, when connected to the
XRpad Interface and Power Unit, can also charge the battery pack, but the charge rate is
much slower.
A charged battery will eventually lose its charge if unused. Upon initial use (or after a
3
prolonged storage period), the battery may require three to four charge/discharge cycles
before achieving maximum capacity.
The actual battery run-time will depend on the power demands made by the X-ray detector.
4
The battery pack is keyed and can only be inserted into the battery charger in one orientation.
5
4336/4343 LBP
95510949H-01 95510949H-02
4.2 Ah
46.6 Wh
35% to 85% 10% to 85%
-10°C to 55°C -20°C to +60°C
0°C to 42°C 0°C to +45°C
15°C to 35°C -10°C to +45°C
500 cycles on average under normal usage conditions.
Battery should be discarded on or before five years from date of
manufacture indicated on the battery label.
www.vareximaging.com
Accessories & Replacement Parts
95510926H
11.1 V
5.8 Ah 2.0 Ah
64.38 Wh 22.2 Wh
 3 hours
10% to 75%
-10°C to 60°C
0°C to 42°C
-20°C to 45°C
15°C to 35°C
IP54
3025 LBP-2
95510926H-02
2.6 Ah
28.86 Wh
10% to 85%
-20°C to +60°C
0°C to +45°C
-10°C to +45°C
45