APEX FORGE M4 Manual Del Usuario página 18

Installing Accessories
-
Press and hold the spindle lock (A), and rotate the shaft by hand until the spindle lock engages the shaft, preventing further rotation.
-
With the spindle lock engaged, use the collet wrench (E) to loosen the collet nut (D), if necessary.
-
Insert the shank of the accessory into the collet .
-
With the spindle lock (A) engaged, tighten the collet nut (D) with the provided wrench (E) until the accessory shank is gripped by the collet. Avoid
excess tightening of the collet nut (D).
Removing Accessories
-
With the spindle lock (A) engaged, loosen the collet nut (D) with the provided wrench (E).
-
Remove the accessory.
Using Mandrels
The most common types of mandrel to use with this tool are the standard mandrel which is used with cutoff
discs, grinding wheels, emery wheels, and cut-off wheels. Screw mandrels are used with polishing wheels
and polishing drums. Drum mandrel are used with sanding drums.
To install:
-
Install the mandrel.
If using the standard mandrel:
-
Press and hold the spindle lock (A).
-
Insert the slot end of the provided wrench into the slot on top of the mandrel and unscrew.
-
Remove mandrel screw and washer.
-
Place desired accessory over mandrel shaft and align accessory hole with mandrel hole.
-
Insert mandrel screw with washer through the accessory and mandrel shaft holes.
NOTE: The mandrel washer should be placed between the mandrel screw and the accessory.
-
Tighten using provided wrench(Figure 7).
- 16 -
Fig.7