Publicidad
Idiomas disponibles
Idiomas disponibles
f)
keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g)
use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the particular type of
power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those
intended could result in a hazardous situation.
5)
Service
a)
Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power
tool is maintained.
Safety instructions for all operations
Safety warnings common for grinding, sanding, wire brushing, polishing, carving or abrasive cutting-off operations:
a)
This power tool is intended to function as a grinder, sander, wire brush, polisher, carving or cut-off tool. Read all safety warnings, instructions,
illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or
serious injury.
NOTE List only those operations that are applicable.
b)
Operations such as grinding, sanding, wire brushing, polishing or cutting-off are not recommended to be performed with this power tool. Opera-
tions for which the power tool was not designed may create a hazard and cause personal injury.
NOTE List only those operations that were not included in the first warning. If all listed operations are applicable, then this warning is omitted,
but all subsequent warnings are given without exclusion.
c)
Do not use accessories which are not specifically designed and recommended by the tool manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe operation.
d)
The rated speed of the grinding accessories must be at least equal to the maximum speed marked on the power tool. Grinding accessories
running faster than their rated speed can break and fly apart.
e)
The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. Incorrectly sized accessories
cannot be adequately controlled.
f)
The arbour size of wheels, sanding drums or any other accessory must properly fit the spindle or collet of the power tool. Accessories that do
- 03 -
Publicidad
