Publicidad
Idiomas disponibles
Idiomas disponibles
Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
Changing the tool
Before any work on the power tool itself, pull the mains plug.
With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.
The Hammer rod protector 1 largely prevents the entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that the Hammer rod protector 1 is not damaged.
A damaged Hammer rod protector should be changed immediately. We recommend having this
carried out by an after-sales service.
Inserting(see gure A)
Clean and lightly grease the shank end of the tool. Insert the tool in a twisng manner into the tool
holder until it latches itself. Check the latching by pilling the tool.
Removing (see gure B)
Push back the Protective lining2 and remove the tool.
CAUTION: The insert tool may become hot during use. There is a risk of burning the hands. Wear Pro-
tective gloves when changing insert
Operation
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which speci ed on
the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power receptacle
while the power switch is in ON position, the demolition hammer will start operation immediately,
which can cause serious accident!
9
Publicidad
