Descargar Imprimir esta página

Siefken SD28 Manual Del Usuario página 27

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Extension cord
When the work area is removed from the power source, use an extension cord of su cient thickness
and rated capacity. The extension cord should be kept as short as practicable.
Starting Operation
Observe correct mains voltage! The voltage of the power source must agree with the voltage speci-
ed on the type plate of the power tool.
For low temperatures, the power tool reaches the full impact rate only after a certain time.
This start-up time can be shortened by striking the chisel in the power tool against the oor one
time.
Shock absorption Equipment 4
The is equipped with an active vibration reduction system, which cuts vibration of that of the
without Active Vibration Reduction. This may signi cantly reduce the exposure level over the total
working period. protect the operator form the e ects of vibration.
Setting the Impact Rate
The electronic control enables step less speed preselection in accordance with the material to be
worked.
The constant electronic control keeps the preselected impact rate nearly constant between no-load
and load conditions.
Built to Exceed
Switch on
Press the switch towards①direction
Switch off
Press the switch towards②direction
3 YEARS
L I M I T E D WA R R A N T Y
10

Publicidad

loading