Publicidad
Idiomas disponibles
Idiomas disponibles
Making the Connection
WARNING!
!
Only use a Torx
any other tool may damage screws and panel.
Power Wiring
1. Open front cover for wiring.
a. Release two screws on top.
b. Release the latches to open front cover.
c. Put down front cover gently.
2. Routing the power wires is possible through the bottom or rear of the enclosure.
Select the location to route the power wiring.
Bottom-fed wiring:
a. Feed the wires from the underside. Make sure the wiring can sufficiently reach the connec-
tors before securing.
b. Continue with the fastening of the wires, see the following step.
Rear-fed wiring:
a. Remove the waterproof cap from the back of the enclosure and insert the waterproof cap in
cable access location on the bottom of the enclosure.
b. Proceed with the following steps.
Installation and Operation Manual
®
Tamper-Resistant T15 screwdriver to secure or remove the screws. Use of
1
3
Water proof cap
13
Making the Connection
2
Publicidad
