Qilive Q.1660 Manual De Instrucciones página 10

4.
Unlocking the volume control - Volume unlock
EN
1.
2.
3.
4.
NB:
This function is deactivated in the default factory settings.
5.3. Macro Power
With Macro Power, you can turn on/off two audiovisual devices at the same time.
To activate the Macro Power function
1.
2.
3.
4.
5.
To deactivate the Macro Power function
1.
2.
3.
4.
5.
NB:
• If an invalid code is entered, the Status LED (2) will blink 3 times then stay solidly
Press the [Vol+] button (6). The setting is activated when the Status LED
(2) blinks 3 times then goes off. The [Vol+] (6), [Vol-] (8) and [MUTE] (22)
buttons have then been successfully transferred.
Simultaneously press the [SETUP] (9) button for approximately 3 seconds
until the Status LED (2) comes on solidly.
Use the corresponding device selection button (e.g. [TV]) to select to
device to which the volume setting has been transferred. Once a selection
has been successfully made, it's confirmed by the Status LED (2) blinking
once then staying lit.
Press the [MUTE] button (22). The Status LED (2) will blink once then
stay solidly lit.
Press the [Vol-] button (8). The setting is deactivate when the Status LED
(2) blinks 3 times then goes off. The [Vol+] (6), [Vol-] (8) and [MUTE] (22)
buttons have then been successfully unlocked.
Simultaneously press on the [MUTE] (22) and [Vol+] (6) buttons for
approximately 3 seconds until the Status LED (2) comes on and stays
solid.
Use the button to select the device that you want to pair with your remote
control (e.g. [TV]). A successful selection is indicated by the Status LED
(2) blinking once then staying solidly lit.
Enter the code [9] [5] [0], and the Status LED (2) will blink twice then
stay solidly lit.
Use the device selection button to select the second device to pair with
your remote control (e.g. [STB]), which should be turned on in future. A
successful selection is indicated by the Status LED (2) blinking once then
staying solidly lit.
Press the [OK] button (17). The setting has been successfully activated
when the Status LED (2) blinks 3 times then going off.
Simultaneously press on the [MUTE] (22) and [Vol+] (6) buttons for
approximately 3 seconds until the Status LED (2) comes on and stays
solid.
Use the button to select the device that you want to pair with your remote
control (e.g. [TV]). A successful selection is indicated by the Status LED
(2) blinking once then staying solidly lit.
Enter the code [9] [5] [0], and the Status LED (2) will blink twice then stay
solidly lit.
Use the device selection button to select the second device (e.g. [STB])
which was previously switched on. A successful selection is indicated by
the Status LED (2) blinking once then staying solidly lit.
Press the [EXIT] button (14). The setting has been deactivated when the
Status LED (2) blinks 3 times then goes off.
10