Publicidad
Idiomas disponibles
Idiomas disponibles
device currently controlled and change the channel on a second device. All other
commands aren't affected.
To activate the Channel Punch-Through function:
1.
Simultaneously press on the [MUTE] (22) and [Vol+] (6) buttons for
approximately 3 seconds until the Status LED (2) comes on and stays
solid.
2.
Use the button to select the device that you want to pair with your remote
control (e.g. [TV]). Once a selection has been successfully made, it's
confirmed by the Status LED (2) blinking once then staying lit.
3.
Enter the code [9] [6] [0], the Status LED (2) will blink twice then stay
solidly lit.
4.
Press the [CH+] button (18) . The Status LED (2) will blink once then stay
solidly lit.
5.
Press the desired device's selection button (e.g. [STB]). The setting is
activated when the Status LED (2) blinks 3 times then goes off.
To deactivate the Channel Punch-Through function:
1.
Simultaneously press on the [MUTE] (22) and [Vol+] (6) buttons for
approximately 3 seconds until the Status LED (2) comes on and stays
solid.
2.
Use the button to select the device that you want to pair with your remote
control (e.g. [TV]). Once a selection has been successfully made, it's
confirmed by the Status LED (2) blinking once then staying lit.
3.
Enter the code [9] [6] [0], the Status LED (2) will blink twice then stay
solidly lit.
4.
Press the [CH-] button (16). The Status LED (2) will blink once then stay
solidly lit.
5.
Press the desired device's selection button (e.g. [STB]). The setting is
deactivate when the Status LED (2) blinks 3 times then goes off.
NB:
If an invalid code is entered, the Status LED (2) will blink 3 times then stay solidly lit. A
new code can then be entered.
5.2.
Audio Volume Punch-Through / Volume Lock/Unlock - Volume
Lock and Unlock
With the Volume Punch-Through button, the commands [Vol+] (6) or [Vol-] (8), and
[MUTE] (22) can ignore the device currently controlled and change the volume of a
second device. All other commands aren't affected.
NB:
On some devices, the [Vol+] (6), [Vol-] (8) and [MUTE] (22) buttons do not have any
function. In this case, the remote control automatically transmits the commands to the
programmed television.
Transferring the volume setting - Volume lock
1.
Simultaneously press the [SETUP] (9) button for approximately 3 seconds
until the Status LED (2) comes on solidly.
2.
Use the corresponding device selection button (e.g. [TV]) to select to
device to which you want the volume setting to be transferred. Once a
selection has been successfully made, it's confirmed by the Status LED
(2) blinking once then staying lit.
3.
Press the [MUTE] button (22). The Status LED (2) will blink once then
stay solidly lit.
9
EN
Publicidad
