Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6.8 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, stainless steel finish or matte black finish
ASSEMBLY INSTRUCTIONS
1.
Shut off the water supply. Remove the old
faucet. Before installation, remove the quick
connector (1) from the free end of the
hose by unscrewing it in a counterclock-
wise direction. Unscrew the nut (2),
and remove the washers (3).
2.
Before installation, ensure that the flange
(2) is placed on the bottom of the new
faucet assembly (1). Retract the hose (3)
up through the faucet body until the hose
fitting is flush with the bottom of the
shank (4). Do not pull the hose fitting
past the shank. Insert the faucet body
through the hole in the sink
NOTE: Do not feed the hose (3) back
down through the spout until step 5.
Optional Escutcheon Installation:
3.
Place the escutcheon (2) and the gasket
(3) on the bottom of the new faucet
assembly (1). Retract the hose (4) up
through the faucet body until the hose
fitting is flush with the bottom of the
shank (5). Do not pull the hose fitting
pass the shank. Insert the faucet body
through the hole in the escutcheon (2).
NOTE: Do not feed the hose (4) back
down through the spout until step 5.
4.
Install the washers (1) and the nut (2) onto
the threaded mounting shank. Lock the nut
(2) into position by tightening the screws
(3). Do not overtighten.
1
3
2
1
2
1
2
4
3
3
1
2
5
3
4
4
1
2
3
Ceramic cartridge
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Total weight: 3.3 lbs
5.
After inserting the hose through the
hole in the sink surface, reattach the
quick connector (1) by screwing it onto
the threaded end of the hose (2) in a
clockwise motion. Hand tighten only.
6.
Push the quick connector (2) firmly
upward and attach it to the receiving
block (1). Pull down moderately to
ensure the connection has been made.
7.
Install the weight clip (1) at the point of
the hose marking "weight here". Insert
the weight (2) onto the clip (1) by sliding
it down onto the clip (1).
Make Connections to Water
8.
Lines:
Use 1/2 in. I.P.S. faucet connections (2), or
use supply line coupling nuts (3) (not
included) with a 3/8 in. O.D. ball-nose
riser (1). Use wrenches to tighten the
connections. Do not overtighten.
NOTE: The hot side inlet tube is
indicated by a label. If the label is not
present, the hot supply tube is the longer
of the two inlet tubes.
2
SPECIFICATIONS
5
6
1
2
7
2
1
1
8
1
3
www.homewerksww.com
1
2
2
2
Publicidad
