cecotec CONGA 999 VITAL Manual De Instrucciones página 20

ENGLISH
Warning
If there is no good access to the charging base, the robot will not be able to return to its charging
position. In that case, once the robot has stopped, take it manually to the charging base.
Pause
- Press the power button on the robot or on the remote control to pause the cleaning
process.
- Press the power button on the robot or on the remote control to resume the cleaning
process. Fig. 22
Return to the charging base
Press the Back home button on the robot or on the remote control in order to send the robot
to the charging base.
Turn off
Hold down the power button to turn the robot off. 23
Warning
The robot vacuum cleaner has a power switch located on its main body. If the robot is not going
to be used for long periods of time, it is suggested to switch it off. If the robot is switched off,
it will restore factory default settings as a safety measure. If we want the robot to operate on
the time programming mode, the switch must always be in the I position. Otherwise, you must
programme it again from the remote control.
Cleaning modes
This robot includes different modes and different functions that can be activated from the
remote control.
Automatic mode
- Press the power button for the robot to start Auto cleaning mode.
- The robot will clean the whole surface, edges, around objects such as tables, chairs etc.
Once it starts running out of battery, it will return to the charging base. Fig. 24
Scrubbing mode
- Attach the mop cloth to the water tank and fill the Wet & dry tank with water.
- Take the dust tank out.
- Install the Wet & dry tank in the robot and select the mode.
- Use the remote control to select the desired scrubbing power level: High, Medium or Low.
- Once you have selected the scrubbing level from the remote control, the robot will start
the All in One function to vacuum, scrub and sweep at once thanks to its Wet & dry tank.
Fig. 25
38
Note
- If you want to sweep the floor, skip the water-filling step.
- If the robot has the Wet & dry tank, when he leaves the charging base, it will turn around
itself to soak the mop.
- To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
- It is recommended to be present when the robot is scrubbing.
- Do not leave the wet mop attached when the robot is in the charging base.
Spiral mode
- The robot will carry out an intense cleaning of a specific area when this mode is activated.
The robot will start cleaning at a specific point and will move outwards performing spiral
movements (1 metre). Then, it will return to the starting point in spiral movements again.
- Once it has finished and returns to the starting point, the robot will start cleaning in Auto
mode until it runs out of battery.
- Before operating the robot with Spot cleaning mode, place it on the spot to be cleaned.
- Press the Spot cleaning button on the remote control or on the App. Fig. 26
Edge mode
- When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
- Press the edge cleaning button on the remote control. Fig. 27
Room mode
- The robot will carry out a 30-minute cleaning cycle when this mode is selected.
- Press the Room mode button on the remote control. Fig. 28
- To ensure an efficient cleaning of the room where the robot is operating, close the door.
Back home mode
Press the Back home button on the robot or on the remote control (house symbol) in order
to send the robot to the charging base. The robot will continue sweeping until it gets to the
charging base.
Manual mode
-Press the arrow buttons on the remote control to use the robot manually.
Suction power level function
Press the suction power level button on the remote control in order to control the robot's
suction power during the cleaning process. There are 3 power levels: Turbo, Normal and Eco.
Fig. 29
ENGLISH
39