Publicidad
Idiomas disponibles
Idiomas disponibles
DESK MOUNTED SCREEN ASSEMBLY
1
2
3
4
1. Using Allen wrench, loosley attach mounting bracket
screen connectors (B, from hardware pack) to work
surface mounting brackets (C) with two socket head
cap screws (F, from hardware pack).
NOTE: Brackets for nesting table are different than shown.
1. Position a work surface mounting bracket (C), take care
to position right and left brackets on correct sides of
work surface, flat against bottom of work surface and
align two rear holes in bracket with two predrilled holes
in worksurface.
2. Use
/
" nut driver to install three wood screws (G, from
1
4
hardware pack) through holes in each work surface
mounting bracket (C) and into work surface.
3. Fully tighten screws.
1. Using 2.5mm Allen wrench, loosen flat head socket
screw (E) and remove end cap (D) from bottom of ver-
tical rail on desk screen (A).
1. Insert mounting bracket screen connectors (B) into
screen (A) vertical rail channel facing work surface and
slide screen downward.
42-2272E (11/05)
2 of 3
Publicidad
